After mounting, check that the main unit is
fitted securely.
Replacing the
rechargeable batteries
Note: Regularly clean the sensor and solar cell
to ensure proper functionality (refer to „Clean-
ing and Care").
Change the rechargeable batteries as follows:
For model HG00375A: Loosen the
screws
(Fig. B).
12
For model HG00375B / HG00375C:
Slide the device upwards until the hangers
release from the receivers
Remove the device from the wall.
Set the ON / OFF switch
(For HG00375A, the ON/OFF switch is in-
side the lamp shade
lamp shade to set the switch.) (Fig. G).
Loosen the fixing screws of the battery
compartment lid
(Fig. D).
10 GB/IE
(Fig. B).
5
to position „OFF"
11
at the base. Open
13
and remove these
8
Remove the batteries
compartment
new rechargeable batteries (Fig. E). Use
only rechargeable batteries of the recom-
mended type (see „Technical details"). Be
sure to insert the batteries in the correct di-
rection. It is indicated in the battery com-
partment.
Close the battery compartment by fixing the
battery compartment lid with the fixing screws.
Return the ON / OFF switch to the position
„ON" before you return the device to the
hooks of the mounting plate.
Winter-time use
4
Due to the low level of solar radiation in the
winter the charging of the batteries may be re-
duced and correspondingly the effectiveness of
the light may decrease. For this reason check that
the solar cell
6
the whole day, despite the low position of the
sun. If necessary, remove ice or snow.
from the battery
10
and replace these with
9
remains clear of shadow for