Storage/Disposal; Storage; Disposal Of The Appliance - SilverCrest SDBS 2200 A1 Mode D'emploi

GB
Fault
IE
Water drips from
the soleplate
Wet patches occur
on the items being
ironed.
The water tank
is fi lled but the
"Water tank empty"
indicator
lighting up.

Storage/disposal

Storage

Disposal of the appliance

18
Possible cause
If the steam ironing is briefl y
interrupted, the cooling steam
condenses in the connecting
hose . This can lead to drips.
.
The set temperature is too low for
steam ironing.
Such patches may occur due to
steam condensing on the ironing
board.
The water tank
attached to the appliance.
keeps
NOTE
► If you are unable to resolve the problem by applying any of the aforemen-
tioned methods, please contact the Customer Service department.
If you plan not to use the appliance for a long period, store it in a clean, dry
place away from direct sunlight.
Under no circumstances should you dispose of the appliance with
the normal household waste. This product is subject to the provisions
of European Directive 2012/19/EU-WEEE (Waste Electrical and
Electronic Equipment).
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations. Please
contact your waste disposal facility if you are in any doubt.
Remedy
This is normal. Hold the iron over
a cloth or container and press
the steam blast button
a few seconds, steam will come
out of the soleplate
of water. Then you can continue
ironing.
Set a temperature suitable for
steam ironing (at least ● ●).
Wipe the wetness from the
ironing board and iron the wet
patches dry (without steam).
is not fi rmly Check that the water tank
is seated correctly on the
appliance.
. After
instead
SDBS 2200 A1