Operation; Please Note; On- Off Switch (Fig. 5/Pos. 2); Blade Speed Regulator (Fig. 5/Pos. 3) - Lux Tools 466958 Manuel D'utilisation

466958.book Seite 32 Montag, 21. Juni 2010 1:47 13

6. Operation

• Through the Universal-saw blade holder (17/19) both scroll saw blades and fretsaw blades
GB
can be used.
Caution!
Always insert the blade so that the teeth point toward the saw table (14)!
Attention!
5.3.3 Tilting the saw table (Fig. 2)
• Loosen the locking screw (8).
• Tilt the saw table (14) to the left or right, till the indicator (10) points to the required angle
value on the scale (9).
Caution:
For precision work you should first carry out a trial cut and then re-adjust the tilt angle
Attention!
as required.
6. Operation

6.1 Please note:

• The saw will not cut wood automatically. The user must guide the wood into the moving the
saw blade to enable the machine to cut it.
• The teeth cut the wood only on the downstroke of the sawblade.
• The user must guide the wood slowly against the saw blade because the teeth are very small.
• Every person using the saw needs certain training period. During this period, some blades
are prone to break.
• When cutting thick timber, be particularly careful not to bend or twist the saw blade. This will
help to prolong saw blade life.

6.2 On- Off switch (Fig. 5/Pos. 2)

• For switching on press the green button.
• For switching off press the red button.
Caution:
The machine is equipped with a safety device to prevent it being switched on again
Attention!
accidentally after a power failure.

6.3 Blade speed regulator (Fig. 5/Pos. 3)

Using the blade speed regulator, you can set the blade speed appropriate to the material to be
cut.

6.4 Carrying out internal cuts

1. A feature of this scroll saw is that it is possible to carry out internal cuts in a panel without
damaging the external side or the circumference of the panel.
WARNING:
TO PREVENT INJURIES DUE TO THE SAW STARTING UP ACCIDENTLY: SET
Attention!
THE SWITCH TO "O" POSITION AND PULL THE PLUG OUT OF THE SOCKET
BEFORE YOU REMOVE OR CHANGE THE SAW BLADE.
2. To carry out internal cuts in a panel: Remove the saw blade, as described in section 5.3.2.
3. Drill a 6.3 mm hole in the panel.
32
466958 V_01/06/2010