Operating Led Light; Operating Laser (Fig. 8/Pos. 21); Saw Blade-Storage (Fig. 6); Cleaning, Maintenance And Ordering Replacement Parts - Lux Tools 466958 Manuel D'utilisation

466958.book Seite 33 Montag, 21. Juni 2010 1:47 13
4. Place the panel on the saw table with the drilled hole above the access hole.
5. Install the saw blade through the hole in the panel and adjust the blade tension.
6. After completing the internal cut, remove the saw blade from the blade holders (as described
in section 5.3.2) and take the panel off the table.

6.5. Operating LED light

• Switch on the machine, as described in 6.2
• The LED-Light (7) can be switched on/off using the switch (4).

6.6. Operating Laser (Fig. 8/Pos. 21)

• Switch on the machine, as described in 6.2.
• The Laser (21) can be switched on/off using the switch (5).
• Unlock the saw blade protection (11), as described in 5.3.1. Fold up the saw blade protec-
tion (11) backwards.
• Using the Laser-Calibrated screw (22), the laser line projected on the workpiece can be cal-
ibrated. For this, loosen the Laser-Calibrated screw (22) and set the Laser (21) accordingly.
Afterwards, retighten the Laser-Calibration screw (22).
Caution!
Set the laser line only with the Laser-Calibration screw (22), not on the laser itself!
Attention!
Risk of injuries due to running saw blade!

6.7 Saw blade-Storage (Fig. 6)

Non-required saw blades can be stored in the saw blade storage cabinet (13). Open and close
the saw blade storage cabinet (13), as shown in Figure 6.

7. Cleaning, maintenance and ordering replacement parts

At first pull the power plug before any cleaning work.

7.1 Cleaning

• Keep safety devices, louvre and engine housing as dust and dirt-free as possible. Rub the
device with clean piece of cloth or blow it clean with compressed air with low pressure.
• We recommend to clean the device immediately after each use.
• Clean the device regularly with wet cloth and some soft soap. Do not use any detergents or
solvents; these could damage the synthetic material of the device. Ensure that water do not
enter into the interior of the device.

7.2 Carbon brushes

In case of excess spark formation, get the carbon brushes checked by a certified electrician.
Caution! Only a certified electrician is allowed to change the carbon brushes.

7.3 Maintenance

The interior of the device do not contain any parts that require servicing.

7.4 Ordering replacement parts:

Please quote the following data when ordering replacement parts:
• Type of the device
• Article number of the device
7. Cleaning, maintenance and ordering replacement parts
466958 V_01/06/2010
GB
33