Lux Tools 466958 Manuel D'utilisation page 27

466958.book Seite 27 Montag, 21. Juni 2010 1:47 13
15. Do not use the cable to pull the plug out of the socket-outlet. Protect the cable from heat, oil
and sharp edges.
16. Do not leave the saw in the rain and never use it in damp or wet conditions.
17. Provide good lighting.
18. Never saw near combustible liquids or gases.
19. Wear suitable work clothes! Never wear loose garments or jewellery.
20. Keep long hair in a hair net.
21. Avoid abnormal working postures.
22. Keep children away from the machine when it is connected to the power supply.
23. Keep your workplace clean of wood scrap and any unnecessary objects.
24. Do not allow other persons, particularly children, to touch the tool or the power cable. Keep
them away from your workplace.
25. Persons working on the machine should not be distracted.
26. After you have switched off the motor, never slow down the saw blade by applying pressure
to its side.
27. Fit only blades which are well sharpened and have no cracks or deformations.
28. Faulty saw blades have to be replaced immediately.
29. Never use saw blades which do not comply with the data specified in this manual.
30. It is imperative to make sure that all the devices used to cover the saw blade are in good
working order.
31. Never dismantle the machine's safety devices or put them out of operation.
32. Damaged or faulty safety devices have to be replaced immediately.
33. Never cut workpieces which are too small to hold securely in your hand.
34. Never load the machine so much that it cuts out.
35. Always press the workpiece firmly against the work top.
36. Never remove loose splinters, chips or jammed pieces of wood when the saw blade is run-
ning.
37. To rectify faults or remove jammed pieces of wood, always switch off the machine first. – Pull
out the power plug!
38. Conversions, adjustments, measurements and cleaning jobs are to be performed only when
the motor is switched off. – Pull out the power plug!
39. Before you switch on the machine, check that all wrenches and adjustment tools have been
removed.
40. When you leave your workplace, switch off the motor and pull out the power plug.
41. Electric installation work, repairs and maintenance are to be carried out only by specialists.
42. All guards and safety devices have to be refitted immediately after completion of any repairs
or maintenance.
43. It is imperative to observe the manufacturer's safety, operating and maintenance instructions
as well as the dimensions quoted in the technical data.
44. It is imperative to observe the accident prevention regulations in force in your area as well as
all other generally recognized rules of safety.
45. Note the information published by your professional associations (VBG 7j).
466958 V_01/06/2010
Table of contents
GB
27