Intended Use - Lux Tools 466958 Manuel D'utilisation

466958.book Seite 29 Montag, 21. Juni 2010 1:47 13
• Mounting-Tool

3. Intended use

The scroll saw is used to cut edged timber or wood-like components. Round materials may be
cut only with suitable clamping systems.
The machine must be used only in accordance with the intended purpose. Any other use is not
intended. The user/operator and not the manufacturer shall bear the liability for caused damages
or injuries of all type.
Please note that our devices has not been designed for the commercial, technical or industrial
use. We do not cover any warranty, if the device is used in trade, handicraft or industrial busi-
nesses as well as in case of similar activities.
Only saw blades suitable for the machine may be used. The use of cutting discs of any type is
prohibited. Components of the intended use is also the compliance with the safety instructions,
as well as the installations instructions and operating instructions in the operating manual.
Personnel operating and maintaining the machine must be familiar with this and must be
informed about possible dangers. Moreover, the applicable accident prevention regulations
should be strictly observed.
Other general regulations related to occupational health and safety areas are to be observed.
Changes in the machine and damages resulted because of it will completely exclude liability of
the manufacturer.
In spite of intended use, certain residual risk factors are not completely eliminated. Due to con-
struction and set-up of the machine, following points may appear:
• Harmful emissions from wood dust when using the product in enclosed rooms.
• Risk of accident through the hand contact in uncovered cutting range of the tool.
• Risk of injuring while changing the tool (risk of cutting).
• Crushing of the finger.
• Hazard due to rebound.
• Tilting of the tool due to inadequate workpiece supporting surface.
• Touching the cutting tool.
• Ejection of branch parts and tool parts.
466958 V_01/06/2010
3. Intended use
GB
29