Before Putting The Machine Into Operation; General; Mounting The Saw On A Workbench; Installation - Lux Tools 466958 Manuel D'utilisation

466958.book Seite 31 Montag, 21. Juni 2010 1:47 13

5. Before putting the machine into operation

5.1 General

• All coverings and security devices have to be properly fitted before putting the machine into
operation.
• It must be possible for the saw blade to run freely.
• When working with wood that has been processed before, watch out for foreign bodies such
as nails or screws etc.
• Before you actuate the On/Off switch, make sure that the saw blade is correctly fitted and
that the machine's moving parts run smoothly.
• Before you connect the machine to the power supply, make sure the data on the rating plate
is the same as that for your mains.

5.2 Mounting the saw on a workbench

1. It is better to mount the saw on a solid wood workbench rather than on a weak plywood stand,
where vibrations and noise are certain to be a nuisance.
2. The tools needed to mount the saw on a workbench are not supplied with the saw. Be sure
to use equipment of at least the following size:
Description:
Hexagon screws M8:
Gaskets Ø 8 mm:
Washers Ø 8 mm:
Hexagon nuts M8:
3. Use only provided mounting-holes (23) for the mounting. Do not over tighten the screws.
Leave enough scope for the rubber feet (24) to develop a good absorbing effect.

5.3 Installation

Caution!
Pull out the power plug before carrying out any maintenance and conversion work on
Attention!
your scroll saw.
5.3.1 Mounting the Saw blade protection (Fig. 3-4)
• Mount the saw blade protection (11) using the socket screws (a) and the nut (b), as shown
in figure 3.
• Lock the saw blade protection (11) subsequently with the Fixing-Screw (12), as shown in Fig-
ure 4.
5.3.2 Changing saw blade (Fig. 7-9)
• Unlock the saw blade protection (11), as described in 5.3.1. Fold up the saw blade protec-
tion (11) backwards. Pull the saw blade-clamping lever (16) upwards to take the tension off
the saw blade (20).
• Loosen the socket screw (c) on upper saw blade holder (17). Open the access panel (18).
Loosen the socket screw (d) on bottom saw blade holder (19). Pull the saw blade (20) up and
out through the table insert (15).
• Install the saw blade in reverse order.
5. Before putting the machine into operation
466958 V_01/06/2010
Quantity:
4
4
4
8
GB
31