Technical Manual (Picture 1-2); Scope Of Delivery - Lux Tools 466958 Manuel D'utilisation

466958.book Seite 28 Montag, 21. Juni 2010 1:47 13

2. Technical manual (Picture 1-2)

46. The machine is designed for indoor installation only.
GB
47. Workpieces smaller than the blade guard may lead to injuries to your hands and fingers. Use
suitable aids!
48. When guiding the workpiece do not place your hands in cramped or awkward positions
where they may slip directly against the blade.
49. Always insert the blade so that the teeth point down toward the table.
50. To avoid broken blades, always set the correct blade tension.
51. Be particularly careful when sawing material with irregular cutting profiles.
52. Take special care when cutting round workpieces such as rods or tubes as they may roll away
from the blade and cause the teeth to jam. Secure such workpieces with a wedge.
53. When you withdraw the workpiece the teeth may get caught in the kerf, particularly if the gap
is blocked by sawdust. If this happens you should switch off the saw, pull out the power plug,
open the kerf with a wedge and pull the workpiece free.
54. Never leave your workplace without switching off the saw first. Wait until the saw stops.
55. Never arrange, glue or assemble any parts on the work table while the saw is running.
56. Do not switch on the saw until you have cleared all material remnants and tools from the work
table. Only the workpiece and any essential aids (wedge) are to be left on the workpiece.
57. Always wear safety goggles.
58. Keep your fingers a safe distance from the blade.
59. Guide the workpiece securely and firmly and do not loosen your grip at any time.
60. Never leave your workplace without switching off the saw first.
61. DO NOT ALLOW YOUR FAMILIARITY WITH THE SAW TO TURN INTO CARELESSNESS.
IT TAKES ONLY FRACTIONS OF A SECOND FOR CARELESSNESS TO RESULT IN
SERIOUS INJURIES.
2. Technical manual (Picture 1-2)
1. Dust extraction adapter
2. Switching On/Off
3. Blade speed regulator
4. Off/On switch LED-Light
5. Switching On/Off Laser
6. Air blowing unit
7. LED light
8. Locking screw
9. Scale
10. Indicator
11. Saw blade protection
12. Fixing-Screw

Scope of delivery

• Scroll saw
• Saw blade protection
28
13. Saw blade-Storage cabinet
14. Saw table
15. Saw table-Insertion
16. Saw blade-clamping lever
17. Saw blade holder top
18. Access panel
19. Saw blade holder bottom
20. Saw blade
21. Laser
22. Laser-Calibration screw
23. Mounting-Holes
24. Rubber feet
466958 V_01/06/2010