Becker Centronic UnitControl UCR520 Notice De Montage Et D'utilisation page 19

Note
The device can be set as a drive controller or group controller using the
encoding switch on the back.
Connection as a drive controller
Caution
• Risk of injury by electric shock.
• Terminal connections must be carried out by an authorised electri-
cian!
• If more than one drive is controlled using the UCR520, the drives
must be decoupled by relay controls. This decoupling is not applica-
ble to Becker drives with electronic limit stop.
Always observe the switched current of the device.
1..Remove.the.protective.caps.
..Connect.the.power.supply.unit.to.the.UCR50.as.follows:
3..Put.the.protective.caps.back.on.the.power.supply.unit.
4..Fix.the.power.supply.unit.in.the.box.
5..Put.the.operating.device.in.the.frame.and.plug.it.into.the.power.supply.unit.
DE
GB
FR
NL
19