Changing Sequences - Anthogyr IMPLANTEO LED Manuel D'utilisation

This is the description of « sequence management » screen according to the representation
Fig. 5

6.3 Changing sequences

Changing sequence can be done :
w either with the screen by pressing on the button of a sequence in the active protocol.
w or with the pedal by pressing on the Button C (see section « 8 – Using the pedal » ).
E
It is important to mention that when a sequence is changed following to a reverse gear, the motor rotation direction
is memorized.
6.4 Display of the graph
Press the icon (Fig.3, rep.8)
Fig. 6
1
45 Rpm
Max 80 N.cm
Graph Screen: Graph Elements
This screen graphically shows the speed in
E
The user should have previously ensured that the graphical option is activated for each active protocol sequence by pressing on the
(Fig.3, rep.9)
button
C
At the end of each sequence for which the user has previously activated the graphical option, the graph for this sequence
will automatically appear in full screen and stays displayed for as long as the screen settings are set for (see section
« 7.3 - Settings » ). Pressing on the screen is enough to go back to the work screen before the time expires.
1
1. Selected sequence / Access to the library (double-click).
2. Delete the selected sequence.
3. Add a sequence after the selected sequence
and select its icon.
4. Activation of recording of torques and speeds
for the selected sequence (graphical function).
5 4
5. To deactivate this function, press in the
2 3
to access the graphical screen (Fig.6).
2 3
35 N.cm 8
1. Speed (Rpm).
2. Maxi. torque reached.
7
3. Torque (N.cm).
4. Curves.
5. Displayed sequence.
6
6. Return to work screen.
4
7. Data back-up « torques and speeds» on USB key.
8. Display of all sequences.
5
green or blue (reverse gear)
(Fig.5, rep.4)
and then ticking the box
IMPLANTEO
Fig.5 :
box.
red graphs.
graphs and torques in
if it is empty.
41
®