Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Mini boring tools (Fig. 2)
Mounting
Secure the mini-boring range tools or
grooving cutters up to Ø 14.7 mm (.579")
1
in the slide using adapter
boring tool reaches its cutting position
when the surface
makes contact. Clamp it to the oblique
surface with a threaded taper pin
(tightening torque 8 Nm (70.81 in. lbs.)).
2
3
4
Fig. 2
Tool holder (Fig. 3)
Mounting
Secure the tool holders in the slide via
mounting surface
2
taper pins
.
Notes on balancing
For optimum utilization of the automatic
balancing, steel tool holders must be used.
The position of the adjuster slide should
not exceed the range of central (= 0) to
max. 1 mm (.039 inch) diameter. See
details on boring range A
our product catalogues
1
Fig. 3
Serrated tool bodies and insert
holders (Fig. 4)
Mounting
The serrated tool bodies
the slide. Fit the insert holders
K-profile of the serrated tool body and
clamp them with the screw
12
3
. The mini
4
at the shank end
5
1
5
1
using two threaded
and A
opt.
max.
2
1
are secured in
3
onto the
4
(tightening
torque 8 Nm (70.81 in. lbs.)). The insert hol-
ders can be preset with a scale on the
serrat ed tool body and on the insert holder
itself. The scale on the insert holder
applies to the central scale position (= 0).
2
2
Fig. 4
Notes on balancing
For balancing reasons, attention should
be given to the following procedures:
The tool slide must be set to the centre
as shown on the scale (= 0). Then preset
the insert holder on the serrated tool
body to the diameter required. Further
corrections can be carried out with the
precision adjustment of the DigiBore
tool via digital display, in which the
in
slide should not be adjusted by more
than 1 mm (.039") diameter.
Serrated slides with coolant delivery
section (page 13), insert holders for
bor ing (Fig. 5), insert holders for outside
turning (Fig. 6) as well as in sert holders
for axial grooving (Fig. 7) and counter-
weight
Mounting
Secure the serrated adapter slides
the slide with four screws
torque 8 Nm (70.81 in. lbs.)). Fit the insert
3
holder
on the K-profile on the appropria-
te side of the rail, set it roughly according to
the scale and fix it with the cheese-head
4
screw
(tightening torque 8 Nm (70.81 in.
lbs.)). The
1
3
4
1
3
4
2
; (tightening
1
on
Publicité
Table des Matières
