Safety Instructions; Safety-Conscious Working - Pentair Jung Pumpen BASICLOGO AD 00E Instructions De Service

ENGLISH
You have purchased a product made by JUNG PUMPEN and
with it, therefore, also excellent quality and service. Se-
cure this service by carrying out the installation works in
accordance with the instructions, so that our product can
perform its task to your complete satisfaction. Please re-
member that damage caused by incorrect installation or
handling will adversely affect the guarantee. Therefore ple-
ase adhere to the instructions in this manual!
This appliance can be used by children aged 8 years or over
and by persons with limited physical, sensory or intellectual
capabilities, or with limited experience and knowledge, pro-
vided that they are supervised or have been instructed in
the safe use of the appliance and are aware of the dangers
involved. Children must not be allowed to play with the ap-
pliance. Cleaning and user maintenance must not be carried
out by children unless they are supervised.
Damage prevention in case of failure
Like any other electrical device, this product may fail due to
a lack of mains voltage or a technical defect.
If damage (including consequential damage) can occur as a
result of product failure, the following precautions can be
taken at your discretion:
• Installation of a water level dependent (under circum-
stances, mains-independent) alarm system, so that the
alarm can be heard before damage occurs.
• Inspection of the collecting tank/chamber for tightness
up to the top edge before – or at the latest, during – instal-
lation or operation of the product.
• Installation of backflow protection for drainage units that
can be damaged by wastewater leakage upon product
failure.
• Installation of a further product that can compensate in
case of failure of the other product (e.g. duplex unit).
• Installation of an emergency power generator.
As these precautions serve to prevent or minimise conse-
quential damage upon product failure, they are to be strictly
observed as the manufacturer' s guideline – in line with the
standard DIN EN specifications as state of the art – when
using the product (Higher Regional Court Frankfurt/Main,
Ref.: 2 U 205/11, 06/15/2012).

SAFETY INSTRUCTIONS

This instruction manual contains essential information that
must be observed during installation, operation and servic-
ing. It is therefore important that the installer and the re-
sponsible technician/operator read this instruction manual
before the equipment is installed and put into operation.
The manual must always be available at the location where
the pump or the plant is installed.
Failure to observe the safety instructions can lead to the
loss of all indemnity.
In this instruction manual, safety information is distinctly
labelled with particular symbols. Disregarding this informa-
6
tion can be dangerous.
General danger to people
Warning of electrical voltage
NOTICE! Danger to equipment and operation NOTICE!
Qualification and training of personnel
All personnel involved with the operation, servicing, inspec-
tion and installation of the equipment must be suitably qua-
lified for this work and must have studied the instruction
manual in depth to ensure that they are sufficiently conver-
sant with its contents. The supervision, competence and
areas of responsibility of the personnel must be precisely
regulated by the operator. If the personnel do not have the
necessary skills, they must be instructed and trained ac-
cordingly.

Safety-conscious working

The safety instructions in this instruction manual, the ex-
isting national regulations regarding accident prevention,
and any internal working, operating and safety regulations
must be adhered to.
Safety instructions for the operator/user
All legal regulations, local directives and safety regulations
must be adhered to.
The possibility of danger due to electrical energy must be
prevented.
Leakages of dangerous (e.g. explosive, toxic, hot) substanc-
es must be discharged such that no danger to people or the
environment occurs. Legal regulations must be observed.
Safety instructions for installation,
inspection and maintenance works
As a basic principle, works may only be carried out to the
equipment when it is shut down. Pumps or plant that con-
vey harmful substances must be decontaminated.
All safety and protection components must be re-fitted
and/or made operational immediately after the works have
been completed. Their effectiveness must be checked be-
fore restarting, taking into account the current regulations
and stipulations.
Unauthorised modifications, manufacture of
spare parts
The equipment may only be modified or altered in agree-
ment with the manufacturer. The use of original spare parts
and accessories approved by the manufacturer is impor-
tant for safety reasons. The use of other parts can result in
liability for consequential damage being rescinded.
Unauthorised operating methods
The operational safety of the supplied equipment is only
guaranteed if the equipment is used for its intended pur-
pose. The limiting values given in the "Technical Data" sec-
tion may not be exceeded under any circumstances.
Instructions regarding accident prevention
Before commencing servicing or maintenance works, cor-