Elba N55 340 Série Mode D'emploi page 23

the hose holder is supplied with the product in a separate kit
(Important: to be used ONLY IF PERMITTED by the local applicable regulations)
GAS CONNECTION WITH RIGID PIPES OR A FLEXIBLE PIPE
The gas connection is made up of:
• the terminal fitting of the inlet pipe
• sealing washer.
Important!
If fitted, remove the hose holder from the terminal fitting of the inlet pipe.
When connecting the cooker to the gas supply with rigid pipes or a flexible pipe,
make sure that
• you use rigid pipes or a flexible pipe complying with applicable local regulations. The
flexible pipe shall be of the correct construction for the type of gas being used.
• if compression fittings are used, you tighten them firmly using two spanners (Fig.
7.3).
• the connection with rigid metal pipes does not cause stress or pressure to the gas
piping.
Gas connection with rubber hose holder
Note: if not already fitted on the inlet pipe,
Inlet pipe
Manifold
male
pipe fitting
Sealing
washer (#)
1/2" G cylindrical
(ISO 228-1) female
Hose holder
for LPG
Hose clamp
(not supplied)
Rubber hose (not supplied)
for LPG connection
(internal diameter 6 mm)
1/2" G cylindrical
(ISO 228-1) male
(#) If not already fitted on the inlet pipe,
it is supplied with the appliance in a
separate kit
LPG
Fig. 7.2
23