Elba N55 340 Série Mode D'emploi page 17

GLASS LID (models with glass lid)
For cleaning purposes, the lid can be ea-
sily removed upwards once taken to the
upright position.
Should the hinges slip off, replace them in
their housing being careful that:
• The right housing must receive the
hinge marked "D" while the left hou-
sing must receive the hinge marked
"S" (Fig. 5.3)
REGULATING OF THE BALANCE
Lower the lid and check the correct balan-
ce.
While opened at 45° it should hang up.
If necessary, register the calibration of the
hinge springs using the screws "R" (fig.
5.3).
SUBSTITUTION
LIGHT
WARNING: Ensure the appliance is
switched off before replacing the lamp to
avoid the possibility of electric shock.
• Let the oven cavity and the heating
elements to cool down.
• Switch off the electrical supply.
• Remove the protective cover.
• Unscrew and replace the bulb with a
new one suitable for high temperatu-
res (300°C) having the following speci-
fications: 230V, E14 and same power
(check watt power as stamped in the
bulb itself) of the replaced bulb
• Refit the protective cover.
Note: Oven bulb replacement is not cove-
red by your guarantee.
OVEN DOOR (some models only)
The internal glass of the oven door can be
easily removed for cleaning by unscrewing
the two fixing screws (fig. 5.4).
OF THE OVEN
Models with glass lid
Do not shut lid when
burner alight.
ATTENTION
Do not lower the glass lid when the
gas burner or electrical plates are
still hot or when the oven is
working or still hot.
Do not lay on the glass lid hot pans
and heavy kitchen utensils.
Dry off any liquid whitch may have
spilt on the cover before opening it.
R
S
Fig. 5.3
D
Fig. 5.4
17