Monitor Ringtone Selection Procedure - Comelit COLOR DIVA MT KIT 11 Manuel Technique

GROUP S.P.A.
The communication is ended by hanging up the handset.
In any case, a call from the external unit always has priority over an
intercom call. In this case, users who are already speaking will hear
a tone similar to the ringtone in the handset if the latter is for them,
or otherwise a triple signal tone.
To answer the call from the external unit, simply lift the handset of
any free unit or hang up and lift the handset of a unit engaged in
the intercom call.
Activation of communication with the external unit interrupts the
intercom conversation previously in progress.
An intercom call does not have priority over a conversation/call with
the external unit.
In this case, during an intercom call attempt, the LED will flash for a
few seconds to signal that the system is engaged.
Two-residence intercom call
mode to send a call to the other units (video entry phones and/or
telephones) set to the two-residence call address, as indicated in
the table on page 35.
By lifting the handset, the receiver of the call communicates with
the caller. The communication is ended by hanging up the handset.
In any case, a call from the external unit always has priority over an
intercom call.
In this case, users who are already speaking will hear a tone similar to
the ringtone in the handset if the latter is for them, or otherwise a triple
signal tone.
To answer the call from the external unit, simply lift the handset of
any free unit or hang up and lift the handset of a unit engaged in
the intercom call.
Activation of communication with the external unit interrupts the
intercom conversation previously in progress.
An intercom call does not have priority over a conversation/call with
the external unit.
In this case, during an intercom call attempt, the LED will flash for a
few seconds to signal that the system is engaged.
Doctor function management
automatic activation of the door lock release with call to the
address of the video entry phone and/or telephone where the
function was activated, by the external unit.
With the function activated, the signalling LED stays on. The Doctor
function is enabled or disabled by pressing the pushbutton set for
that function for 2 seconds.
Privacy Service management
the exclusion of the call from the external unit or switchboard.
NOTE The Doctor and Privacy functions may NOT be activated at
the same time.

Monitor ringtone selection procedure

The user can select the monitor ringtone from a list of available
ringtones, carrying out the following procedure:
1 Keep the pushbutton pressed until a confirmation tone
sounds (this operation is only possible with the system in
standby mode; otherwise the signalling LED will flash to warn
the user).
38
MT KIT
Press the pushbutton set in this
The Doctor function enables
The Privacy function enables
2 Press and release the pushbutton:
once (a confirmation tone sounds) to change the call ringtone
from external unit.
twice (2 confirm tones emitted) to change the switchboard call
tone.
three times (3 confirmation tones sound) to change the door
bell ringtone.
Any further pressing on the
sequence described above.
After the last time the
confirmation tone before proceeding to the next stage.
3 Press and release the
available ringtones in sequence. If you want to hear the same
ringtone several times, keep the
4 Press the key to confirm selection of the last ringtone
heard and to exit (at any time) the monitor ringtone change
mode. On exiting monitor ringtone change mode a
confirmation tone will sound.
pushbutton repeats the
pushbutton is pressed, wait for a
pushbutton to scroll the various
pushbutton pressed.