Installation Instructions Art. 4875Kc, 4876Kc - Comelit COLOR DIVA MT KIT 11 Manuel Technique

Installation instructions Art. 4875KC, 4876KC

• Wall-mount the box 160÷165
cm above the level of the
finished floor, in an area where
it is easy to view the visitor.
If possible it should not point
into the sun or at other direct
light sources (lamps, reflective
surfaces, etc.)
• Fix the frame on the flush-
mounting box using the 2
screws supplied.
• Insert the terminal block and
connect the wires according to
the diagram.
• Fit the snap-on module onto
the terminal and fix it with the 2
screws provided.
-
+
C
M I
-
-
+
+
-
+
3
2
1
1
2
3
CLOSE
MT KIT
• Remove the stainless steel
front to carry out volume
adjustments and adjust the
camera.
NOTE Loosen the four screws
slightly to unlock the camera
and allow adjustment.
• Alternative microphone
position.
4
5
• To remove name tag holder,
insert the tip of the screwdriver
in the middle opening and
extract it.
• After adjusting, fix the trim by
means of the 2 bottom screws.
NOTE To remove the trim,
undo the 2 bottom screws,
OPEN
turning max. 360°.
25
MT KIT