Angelcare AC201 Guide De L'utilisateur page 19

Problem
Power Indicator (green light) does not
light up.
There is very weak reception.
There is static, distortion,
interference, etc.
There is feedback
(squealing noises).
IMPORTANT! This Angelcare® monitor is a personal care product.
Please do not return this product to the store. If you have questions or need help, please
Warranty Information (USA & Canada only) www.angelcare-monitor.com
Register your Angelcare monitor and other Angelcare products on our website: www.angelcare-monitor.com
Possible Cause
Batteries are low or improperly
installed.
AC adapters are not connected
properly or electrical outlet is
out of order.
One of the units is not on.
Parent and Nursery Units are
too far apart.
One or both units are placed
near a large metal mass.
One or both units are not in the upright
position.
Batteries are low.
Parent and Nursery Units are
too far apart.
Units are not set to the same channel.
One of the units is not on.
The Parent Unit is located near motorized
devices, fluorescent lights, television, etc.
Units are too close to each other.
The volume is too high.
call Angelcare before returning this product.
Replacement Parts
angelcare@cdecinc.ca -
REGISTER ANGELCARE PRODUCTS
3980, rue Saint Ambroise, Montréal, Québec, H4C 2C7, Canada
1-877-281-8827
19
Solution
Check or replace batteries.
Check connections or change to another
electrical outlet.
Make sure both units are on the same
channel, either both on A or B.
Bring Parent Unit closer to
Nursery Unit.
Change the position of one or
both units.
Place units on flat surface away from
baby's reach.
Check or replace batteries.
Bring Parent Unit closer to
Nursery Unit.
Make sure both units are on the same
channel, either both on A or B.
Make sure both units are on.
Rotate Parent Unit or move
it away from source of
interference.
Move units farther apart (at least 10 feet
apart).
Decrease volume on Parent Unit.