Angelcare AC201 Guide De L'utilisateur page 15

Tips For Using Your Monitor
• When the monitor is in use, do not use a crib mobile or other crib accessories that may produce vibrations.
Other sources of vibrations may include fans, washing machines, loud music, etc. These sources of vibration
may interfere with the performance of your Angelcare® monitor and the alarm will not sound if it continues
to detect any movement. Be sure all vibration sources are eliminated before using the monitor.
• There are several reasons you may experience false alarms. The most common reason is the Nursery Unit
has not been turned off after you have removed your baby from the crib. Another reason is the Sensor Pad has
not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, hard surface with the print-
ed side facing up. The sensitivity level may also need to be adjusted. Refer to the Movement Sensitivity
Adjustment section.
• Your monitor can be used in any crib that is stationary and designed to safely hold a baby. If the crib has a
spring or slat base, place a hard board between the crib base and the Sensor Pad measuring at least 13" x 13"
(33x33 cm) and 1/4 inch (6 mm) thick. Only use your Angelcare® monitor in a stationary sleeping environ-
ment such as a crib where the Sensor Pad can rest on a completely flat and firm surface.
• When unplugging the AC adapter from each unit, be sure the unit is switched to the off position. If it isn't,
the unit will revert to battery mode if batteries are installed.
• You can use rechargeable batteries, however, a rechargeable battery cannot be recharged by plugging in the
AC adapter. Remove batteries from the unit to recharge.
• The range of this monitor is approximately 300 feet. However, the range will vary depending on the sur-
roundings. Test the range before use. NOTE: This monitor is not equipped with an out-of-range indicator. No
sound will be received if the Nursery Unit and Parent Unit are too far apart.
15