Repair And Warranty - Megger DLRO-10 Guide De L'utilisateur

Duplex 3.8 cm (11⁄2") Kelvin Clips. (2)
Single Leads
Single handspikes (2) for potential measurement. 2m/7 ft
Current clips (2) for current connections. 2m/7 ft
2m/7 ft 242006-7
5.5m/18ft 242006-18
9m/30 ft 242006-30
242021-7
5.5m/18ft 242021-18
9m/30 ft 242021-30
242041-7
5.5m/18ft 242041-18
9m/30 ft 242041-30

REPAIR AND WARRANTY

The instrument circuit contains static sensitive devices, and care must
be taken in handling the printed circuit board. If the protection of an
instrument has been impaired it should not be used, and be sent for repair
by suitably trained and qualified personnel. The protection is likely to be
impaired if, for example, the instrument shows visible damage, fails to
perform the intended measurements, has been subjected to prolonged
storage under unfavourable conditions, or has been exposed to severe
transport stresses.
New Instruments are Guaranteed for 1 Year from the Date of
Purchase by the User.
Note: Any unauthorised prior repair or adjustment will automatically
invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact:-
Megger Limited or
Archcliffe Road
Dover
Kent, CT17 9EN.
England.
Tel: +44 (0) 1304 502100
Fax: +44 (0) 1304 207342
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been
approved for repair work on most Megger instruments, using genuine
Megger spare parts. Consult the Appointed Distributor / Agent regarding
spare parts, repair facilities and advice on the best course of action to take.
Megger
Valley Forge Corporate Centre
2621 Van Buren Avenue
Norristown, PA 19403
U.S.A.
Tel: +1 (610) 676-8579
Fax: +1 (610) 676-8625
23