Battery Fitting And Replacement - Megger TDR1000/2 Guide De L'utilisateur

Battery fitting and replacement
When the low battery symbol
display window the cells are nearly exhausted and
should be replaced as soon as possible. Use alkaline
cells IEC LR6 (AA) 1.5V or 1.2V rechargeable cells
only.
To install or replace the cells, switch the instrument
off. Disconnect the test leads, loosen the battery
cover retaining screws and remove the cover. Lift out
and disconnect the battery holder.
Replace the cells, ensuring that correct polarity is
observed (shown on the battery holder).
Incorrect battery cell polarity can cause electrolyte
leakage resulting in damage to the instrument
R e fitting the battery holder is the reverse of re m o v i n g
i t .
appears in the
7