Repair And Warranty - Megger BT51 Guide De L'utilisateur

Repair and Warranty

The instrument circuit contains static sensitive devices, and care must
be taken in handling the printed circuit board. If the protection of an
instrument has been impaired it should not be used, and be sent for repair
by suitably trained and qualified personnel. The protection is likely to be
impaired if, for example, the instrument shows visible damage, fails to
perform the intended measurement, has been subjected to prolonged
storage under unfavourable condition, or has been exposed to severe
transport stresses.
New Instruments are Guaranteed for 1 Year from the Date of Purchase by
the User.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact:
Megger Limited or
Archcliffe Road
Dover
Kent, CT17 9EN.
England.
Tel: +44 (0) 1304 502243
Fax: +44 (0) 1304 207342
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been approved
for repair work on most Megger instrument, using genuine Megger spare
parts. Consult the Appointed Distributor / Agent regarding spare parts,
repair facilities and advice on the best course of action to take.
12
Megger
Valley Forge Corporate Center
2621 Van Buren Avenue
Norristown, PA 19403
U. S. A.
Tel: +1 (610) 676-8579
Fax: +1 (610) 676-8625
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent
freight pre-paid to the appropriate address. A copy of the Invoice and of the
packing note should be sent simultaneously by airmail to expedite clearance
through Customs. A repair estimate showing freight return and other
charges will be submitted to the sender, if required, before work on the
instrument commences.
WEEE
The crossed out wheeled bin placed on the Megger products is a reminder
not to dispose of the product at the end of it's product life with general
waste.
Megger is registered in the UK as a Producer of Electrical and Electronic
Equipment.
The Registration Number is WEE/HE0146QT
Batteries
The crossed out wheeled bin placed on the batteries is a reminder not to
dispose of them with general waste at the end of their life.
This product contains a NiCad battery pack 7.2V 4Ah (6VR4)
Battery replacement should only be performed by a Megger authorised
repair agent, who will correctly dispose of the spent battery.
For the purpose of end of life disposal only, the battery can be accessed by
removing the four recessed screws on rear of instrument and lifting off front
panel.
Spent NiCad batteries from the BT51 are classified as Industrial