Battery Fitting And Replacement; Care And Maintenance - Megger TDR1000/2 Guide De L'utilisateur

Battery fitting and replacement

When the low battery symbol
display window the cells are nearly exhausted and
should be replaced as soon as possible. Use alkaline
cells IEC LR6 (AA) 1.5V or 1.2V rechargeable cells
only.
To install or replace the cells, switch the instrument
off. Disconnect the test leads, loosen the battery
cover retaining screws and remove the cover. Lift
out and disconnect the battery holder.
Replace the cells, ensuring that correct polarity is
observed (shown on the battery holder).
Incorrect battery cell polarity can cause electrolyte
leakage resulting in damage to the instrument
Refitting the battery holder is the reverse of
removing it.

Care and Maintenance

appears in the Care and Maintenance
Other than replacing the batteries, the instrument has
no user serviceable parts. In case of failure it should
be returned to your supplier or an approved Megger
Limited repair agent.
Cleaning the instrument should only be done by wiping
with a clean cloth dampened with soapy water or
Isopropyl Alcohol (IPA).
WEEE
The crossed out wheeled bin placed on Megger products
is a reminder not to dispose of the product at the end of
its life with general waste.
Megger is registered in the UK as a Producer of Electrical
and Electronic Equipment.
The Registration number. is WEE/HE0146QT
Batteries
The crossed out wheeled bin on the batteries is a
reminder not to dispose of them in the general waste at
the end of their life.
The batteries used in this instrument are classified as
portable batteries and should be disposed of in the UK
in accordance with Local Authority requirements. For
disposal of in other parts of the EU contact your local
distributor.
Megger is registered in the UK as a producer of batteries.
The Registration number is BPRN00142
7