Service Data - Zanussi ZOP37912XC Notice D'utilisation

Problem
The display shows "F102".
The display shows an error
code that is not in this table.
The appliance is activated and
does not heat up. The fan does
not operate. The display shows
"Demo".

SERVICE DATA

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
24
Possible cause
• You did not fully close the
door.
• The door lock is defective.
There is an electrical fault.
The demo mode is activated.
We recommend that you write the data here:
•
•
•
•
•
1. Deactivate the oven.
2. Press and hold the button
3. The first digit on the dis-
4. Enter the code 2468 by
5. The next digit starts to
6. Demo mode deactivates
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
Remedy
Fully close the door.
Deactivate the oven with
the house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows "F102"
again, contact the Custom-
er Care Department.
Deactivate the oven with
the house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows the er-
ror code again, contact the
Customer Care Depart-
ment.
.
play and Demo indicator
start to blink.
pressing the buttons
to change the values
and press to confirm.
blink.
when you confirm the last
digit and the code is cor-
rect.
or