Service Data - Zanussi ZOP27901 Notice D'utilisation

Problem
The display shows "F102".
The display shows an error
code that is not in this table.
The appliance is activated and
does not heat up. The fan does
not operate. The display shows
"Demo".

SERVICE DATA

If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
22
Possible cause
• You did not fully close the
door.
• The door lock is defective.
There is an electrical fault.
The demo mode is activated.
We recommend that you write the data here:
• Fully close the door.
• Deactivate the oven with
the house fuse or the safety
switch in the fuse box and
activate it again.
• If the display shows "F102"
again, contact the Custom-
er Care Department.
• Deactivate the oven with
the house fuse or the safety
switch in the fuse box and
activate it again.
• If the display shows the er-
ror code again, contact the
Customer Care Depart-
ment.
1. Deactivate the oven.
2. Press and hold the button
3. When an acoustic signal
4. Turn the knob for the oven
5. Release the button
6. Turn the knob for the tem-
the appliance cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
Remedy
.
sounds, turn the knob for
the oven functions clock-
wise to the first function.
"Demo" flashes in the dis-
play.
functions to the off posi-
tion.
.
perature clockwise and
hold it for three seconds.
The acoustic signal
sounds three times. The
demo mode is deactivated.