Additional Adjustments - KROHNE OPTIBAR PM 5060 C Manuel De Référence

MISE EN SERVICE
5

5.6.4 Additional adjustments

PIN In this menu item the PIN can be changed. This option is only available if it has been enabled under
"Setup - Lock adjustment". The PIN is "0000" by default factory conditions.
0000
Date / Time Internal clock setting
Write date, time, data in device
Reset For more information se référer à
Delivery status and Basic settings
Copy instrument For more information se référer à
settings
Copy instrument settings
Special Changing these settings is possible only after consultation with a service employee.
parameters
Scaling In menu item "Scaling variable" you define the scaling variables and the scaling unit for the level
mode.
In menu item "Scaling format" you define the scaling format on the display and the scaling of the
level measurement for 0% and 100%.
Scaling variable
Scaling format
Current output In this menu item it is determined which measured variable relates to which current output. Under
"Current output - Adjustment", the current output can be assigned a corresponding measured
value.
Current output
variable
The selection is
limited to linear
percent for devices
with SIL-qualification.
Current output
adjustment
®
HART -Mode The converter offers the HART
"Fix current (4 mA)", up to 64 sensors can be operated on a two-wire cable in multidrop mode. Each
device must be assigned a HART
Under "Analogue current output", however, a 4...20 mA signal can also be issued for the assigned
HART
HART
Output mode
Tableau 5-4: Additional adjustments
1 Only available for electronic differential pressure when the slave sensor is activated
62
Change PIN
Scaling variable
Scaling unit
Scaling format
100% corresponds - user-defined value
0% corresponds - user-defined value
For applications Process pressure
Process pressure, Percent, Linear percent, Meas. cell temp. and
Electronics temperature
For applications Level
Filling height or Process pressure (Adjustment units), Percent, Scaled,
Linear percent, Meas. cell temp. and Electronics temperature
For applications Differential pressure 1
Differential pressure, Static pressure, Percent, Linear percent, Meas. cell
temp. and Electronics temperature
For applications Density 1
Density, Differential pressure, Percent, Scaled, Linear percent, Meas. cell
temp. and Electronics temperature
For applications Interface 1
Interface height, Differential pressure, Percent, Scaled, Linear percent,
Meas. cell temp. and Electronics temperature
0% = 0% or 100% = 100%
®
®
address in multidrop mode.
0...63
®
address
Analogue current output with HART
Reset
à la page 63.
Sauvegarde des réglages de l'appareil
modes "Analogue current output" and "Fix current" (4 mA)". Under
®
address between 0 and 63. The analogue signal is fixed at 4 mA.
www.krohne.com
OPTIBAR PM 5060 C
à la page 65.
®
or Fix current (4 mA) with HART
01/2021 - 4004819802 - MA OPTIBAR PM 5060 C R04 fr
®