Diagnostics - KROHNE OPTIBAR PM 5060 C Manuel De Référence

OPTIBAR PM 5060 C

5.6.3 Diagnostics

Device status Status signals
Peak value The respective minimum and maximum pressure values are stored in the device. Under "Peak
values", these values can be viewed or reset. In addition to the pressure, the minimum and maximum
values of the sensor cell and the electronics temperature is stored. These can be viewed or reset
here.
Peak value
Process pressure
Peak value
Differential pressure 1
Peak value
Static pressure 1
Peak value
Meas. cell temp.
Peak value
Electronic temperature
Simulation In menu item "Simulation", measured values can be simulated via the current output. These are
issued as both analogue and digital (via HART
minutes after the last key stroke.
Process pressure
Level
Differential pressure 1
Density 1
Interface 1
Tableau 5-3: Diagnostics
1 Only available for electronic differential pressure when the slave sensor is activated
01/2021 - 4004819802 - MA OPTIBAR PM 5060 C R04 fr
Check function, Out of Specification, Maintenance required, Failure
Reset peak value
Reset peak value
Reset peak value
Reset peak value
Reset peak value
®
). The simulation is automatically cancelled 60
Process pressure, Percent, Current output, Linear percent, Meas.
cell temp. and Electronics temperature
Filling height or Process pressure (Adjustment units), Percent,
Current output, Linear percent, Meas. cell temp. and Electronics
temperature
Differential pressure, Static pressure, Percent, Current output,
Linear percent, Meas. cell temp. and Electronics temperature
Density, Differential pressure, Percent, Current output, Linear
percent, Meas. cell temp. and Electronics temperature
Interface height, Differential pressure, Percent, Current output,
Linear percent, Meas. cell temp. and Electronics temperature
www.krohne.com
MISE EN SERVICE
5
61