Spare Parts; Accessory; Maintenance And Disposal - SKF TWIM 15 Mode D'emploi

10. Spare parts

Designation
TWIM 15-3

11. Accessory

Designation
TWIM 15-BAG
R E M A R K S :
• The bag does not protect the heater against
heavy impacts.
• Do not operate the heater inside of the bag.
• The bag is not heat resistant, do not place hot
bearings against it or inside of it.
• The TWIM 15-BAG is optional to the TWIM 15
induction heater.

12. Maintenance and disposal

• Store the heater in a dry area, with low
humidity (0-95% non-condensing).
• Store and transport the heater within a
temperature range of 0- 50 °C (32 - 122 °F).
• Keep the heater clean with a soft dry cloth.
Remove all oil drippings that might remain after
use.
• The heater does not require any specific
maintenance nor regular calibration.
• Do not try to fix the heater yourself.
Approach your SKF contact person or distributor
if there is any malfunctioning or preventive
repair needed.
• The heater is calibrated during production.
If some repairs are performed, the heater needs
to be recalibrated.
• In case of disposal of the heater, take the
necessary measurements to recycle it.
Do not dispose it in a general waste bin.
Description
Magnetic K-type probe 400mm (1.31 ft)
Description
Carrying and storage bag for TWIM 15
Size: 450 x 450 x 100 mm
Colour: Black
Material: Outside - Polyester (1680D) / Lining- EVA-foam and PU
Fig. 3 & 4 – Carrying and storage bag for TWIM 15
EN 15