Instructions And Safety Information; Guidelines Used And Ce Certification; General Safety - Xylem LOWARA Sekamatik 12MK7 Manuel D'installation, D'exploitation Et De Maintenance

Level control
The level control is designed to switch the product on or off depending on the filling level. This is made possible
by installing a float switch.
2. Safety
This chapter lists all the generally applicable safety instructions and technical information. Furthermore, every
other chapter contains specific safety instructions and technical information. All instructions and information must
be observed and followed during the various phases of the product's lifecycle (installation, operation,
maintenance, transport etc.). The operator is responsible for ensuring that personnel follow these instructions and
guidelines.

2.1. Instructions and safety information

This manual uses instructions and safety information for preventing injury and damage to property.
To make this clear for the personnel, the instructions and safety information are distinguished as follows:
Each safety instruction begins with one of the following signal words:
Danger: Serious or fatal injuries can occur!
Warning: Serious injuries can occur!
Caution: Injuries can occur!
Caution (Instruction without symbol): Serious damage to property can occur, including irreparable damage!
Safety instructions begin with a signal word and description of the hazard, followed by the hazard source and
potential consequences, and end with information on preventing it.

2.2. Guidelines used and CE certification

Our products are subject to
- various EC directives
- various harmonized standards
- various national standards.
Please consult the EU Declaration of Conformity for the precise information and the guidelines and norms in
effect.
Also, various national standards are also used as a basis for using, assembling and dismantling the product. The
CE symbol is found either on the type plate or next to the type plate. The type plate is attached to the motor
casing.

2.3. General safety


Never work alone when installing or removing the product.

The machine must always be switched off before any work is performed on it (assembly,
dismantling, maintenance, installation). The machine must be disconnected from the electrical
system and secured against being switched on again. All rotating parts must be at a standstill.

The operator should inform his/her superior immediately should any defects or irregularities occur.

It is of vital importance that the system is shut down immediately by the operator if any problems
arise which may endanger safety of personnel. Problems of this kind include:




Tools and other objects should be kept in a place reserved for them so that they can be found
quickly.

Sufficient ventilation must be provided in enclosed rooms.

When welding or working with electronic devices, ensure that there is no danger of explosion.

To prevent suffocation and poisoning caused by venomous gases, make sure that enough oxygen
exists at the workplace.

Immediately after repair or maintenance work, all safety and protection equipment must be
reinstalled and placed in function again.

All other rules and regulations and local codes covering health and safety must be observed. In
accordance with product liability law, we point out that we shall not be liable for damages caused by
the pump due to non-observance of the instructions and guidelines set forth in the operating
instructions. The same product liability are valid for accessories.
These instructions must be strictly observed. Non-observance can result in injury or serious
damage to property.
6
Failure of the safety and/or control devices
Damage to critical parts
Damage to electric installations, cables and insulation.