General Information; Safety Features - EINHELL ROYAL MKS 38/40 Mode D'emploi

Anleitung MKS 38-40 SPK 1
GB

GENERAL INFORMATION

2
5
9
16
18
15
4
8
21 20
19
1. Guide Bar 8.
2. Saw chain 9.
3. Saw Chain Adjustment Screw 10. Stop Switch
4. Spark Arrester Screen 11. Safety Trigger
5. Chain Brake Lever / Hand 12. Oil Tank cap
Guard 13. Starter Cover
6. Front Handle 14. Fuel Tank Cap
7. Starter Handle 15. Rear Handle / Boot Loop
Numbers preceding the descriptions correspond with the numbers on preceding page to help you locate the safety
feature.
2 LOW KICKBACK SAW CHAIN helps significantly
reduce kickback, or the intensity of kickback, due to
specially designed depth gauges and guard links.
4 SPARK ARRESTER SCREEN retains carbon and
other flammable particles over 0.023 inches (0.6mm)
in size from engine exhaust flow. Compliance with
local, state and federal laws and/or regulations gov-
erning the use of a spark arrester screen is the user's
responsibility. See Safety Precautions for additional
information.
5 CHAIN BRAKE LEVER / HAND GUARD protects the
operator's left hand in the event it slips off the front
handle while saw is running.
5 CHAIN BRAKE is a safety feature designed to
reduce the possibility of injury due to kickback by
stopping a moving saw chain in milliseconds. It is acti-
vated by the CHAIN BRAKE lever.
10 STOP SWITCH immediately stops the engine when
16
10.05.2004 15:05 Uhr
6
14
1
3
22
13
23
Spark Plug 16. Throttle Latch
Air Cleaner Cover 17. Chock Lever
18. Bar Retaining Nuts
19. Throttle Trigger
20. Chain Catcher
21. Muffler Shield / Clutch Cover
22. SPIKED BUMER
23. Guide Bar Cover

SAFETY FEATURES

tripped. Stop switch must be pushed to ON position
to start or restart engine.
11 SAFETY TRIGGER prevents accidental acceleration
of the engine. Throttle trigger (19) cannot be
squeezed unless the safety latch is depressed.
20 CHAIN CATCHER reduces the danger of injury in
the event saw chain breaks or derails during
operation. The chain catcher is designed to intercept
a whipping chain.
21 MUFFLER SHIELD / CLUTCH COVER helps pre-
vent hands and combustible materials from making
contact with a hot muffler.
22 SPIKE BUMPERThe spiked bumper is used for
your personal safety and ease of cutting. Spiked
bumper will increase your stability while performing
vertical cutting.
NOTE: Study your saw and be familiar with its parts.
Seite 16
7
17
10
11
12