ROSIERES RCP12IN Notice D'emploi Et D'installation page 66

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- 30
- CONNECTION BY SOFT RUBBER TUBE
Screw the compliant end piece*
Fit the soft tube to the end piece on the one hand and to the regulator or to the
valve outlet on the other hand.
We do not recommend this type of connection. To be reserved solely for old
installations not enabling any other option.
* In all cases, make sure the seal is fitted. Following the connection operations,
test the leak tightness using soapy water, testing by flame is strictly
prohibited.
If the gas type has been altered, the stability of the flame in the minimum
flow must be checked and set by adjusting the bypass screw.
To access the top burner bypass screw, remove the control panel knobs.
a) natural gas
. unscrew the bypass screw one turn
. replace the knob, light the burner and set to low.
. remove the knob, screw
obtained, staying stable when going from high to low position. Replace the knob.
b) butane-propane:
forcing) the bypass screw whose calibrated hole provides the minimum flow.
To access the hob burner's bypass screw, remove its knob.
a) natural gas:
screw
turns, replace the knob and light the burner, set it to low (to the stop), remove
the knob, and screw the bypass screw
stable when going from high to low position. Replace the knob.
b) butane-propane:
screw whose calibrated hole provides the minimum flow.
burner
bypass screw
MINIMUM FLOW ADJUSTMENT
the bypass screw until a reduced flame is
the setting is done by screwing
the bypass screw right in then unscrew it by two
the setting is done by screwing
Butane/Propane
Natural
.
to obtain a low flame that stays
to the stop the bypass
right in (without

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rcp12pn

Table des Matières