Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OVENS
. Whatever the cleaning method, do not let fatty residues accumulate inside the
oven. Clean it regularly.
. Never line the oven sides with aluminium foil or single-use commercial
protection; this concentrates the heat causing the enamel to deteriorate.
- Oven doors: the door can be cleaned in situe or can be removed.
. Remove as follows:
. fully open the door; the hinge appears as in photo 1;
. lift the hinge pins (photo 2) and pull the door upwards partially closing it until
released.
For installation, make sure you reposition the hinges carefully; a notch located
below them (photo 3) lets you fit the hinges correctly.
After the door is put back on its supports, fit the hinge pins in their initial position
as in photo 4.
1: initial position
with pin to bottom
<------------ Removal --------------------> <----------------- Installation -------------->
- Oven door glass: after each use of the oven, wipe using absorbent kitchen
roll. If there is a lot of spattering, clean the glass with a sponge and detergent.
Rinse and dry.
- Oven lighting:
Disconnect all power supplies from the oven before cleaning or replacing the
bulb. The bulb and its cover are made of material resistant to high temperatures.
2: lift the pin
Bulb characteristics:
230 V AC - 25 W – Base E 14 - Temperature 300°C.
To change a defective bulb, just:
. unscrew and remove the glass cover,
. unscrew the bulb;
. replace it with the same type: see characteristics
above;
. after replacing the defective bulb, screw back the
protective glass cover.
3: hinge notch
21 -
Publicité
Table des Matières
