This must be done in compliance with the regulations in force in the installation
country. In all cases, on the gas feed pipe provide a stop cock, a regulator or
regulator release device for propane gas. Only use valves, regulators, ends and
flexible tubes, regulators with the official mark of the installation country.
GAS CONNECTION ACCORDING TO INSTALLATION:
Natural
Rigid, Flexible hose with mechanical fittings (1)
Butane
Rigid, Flexible hose with mechanical fittings (1), Soft rubber tube (2)
Propane Rigid, Flexible hose with mechanical fittings (1), Soft rubber tube (2)
1 – Provided the flexible hose can be inspected for its entire length.
2 – Provided the soft rubber tube can be inspected for its entire length, its length
does not exceed 1.5 metres and it is fitted with suitable clamps at the ends.
1, 2 – Soft tubes and flexible hoses with mechanical fittings must be arranged to
be away from any flames, and not deteriorated by the combustion gases, hot
cooker parts or by any spills of hot food.
Cylindrical fittings
series
tapered
228-1
ISO 7-1
THREE CONNECTION OPTIONS:
- RIGID PIPE CONNECTION
Connect directly to the manifold fittings.
- CONNECTION BY FLEXIBLE HOSE WITH MECHANICAL FITTINGS
Screw the hose nuts directly onto the manifold fitting on the one hand and onto
the stop cock of the piping on the other hand.
GAS CONNECTION
Caution: according to the regulations
in force in certain countries (see gas
table page 26, it is compulsory to
replace
production mounted on the cooker
with a tapered fitting* supplied with
the unit.
* without forgetting to fit the seal.
the
cylindrical
fitting
29 -