Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Hot plate burner jet
Air ring
The cast-iron top has to be removed
after taking off the hot plate using the
hook (see page 19).
The cast-iron plate is held:
. At the back by two screws located
under
the
back
plate
(unscrew
them), and at the front by two pins
located under the control panel.
Open the oven door and unscrew
them.
Jet located under the
To access the jet, loosen the air ring
air ring.
and push it backwards. Loosen the
jet with a 7 mm spanner holding the
jet holder with a 16 mm spanner. Fit
the jet suited to the burner type and
the gas supply. Do not forget to
replace the air ring in its initial
position.
ADJUSTING THE AIR RING
Adjusting the air ring of the top burners and the hob burner.
This lets you obtain correct combustion and maximum burner efficiency. The
table on page 28 gives the dimension "X" in mm; it may be necessary to adjust
this setting in a range +/- 1 mm to improve the flame's appearance and quality.
1 – Top burners:
To access the burner air rings, remove the burner grills and caps.
The air ring is located in the extension of the burner body, and fixed with a
screw.
Unscrew the air ring. Adjust the air ring according to the dimensions given in the
table. Lock the fixing screw. Install the various parts again.
Semi-rapid or rapid burner
Ultra-rapid burner
«x»
«x»
27 -
Publicité
Table des Matières
