ROSIERES RCP12IN Notice D'emploi Et D'installation page 61

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Section 6
The installation of household appliances is a delicate operation that, «if
not done correctly», can have serious consequences for consumer safety.
Therefore, this work must be entrusted to a professional who can carry
it out in compliance with the technical standards in force.
Rosières will not accept any responsibility in case of technical failure of
the product whether or not it causes damage to goods and/or persons if
the installation has not been carried out by a qualified engineer/gas
fitter.
• Before installation, the technician should:
. Check the compatibility between the cooker and the gas installation.
The cooker is factory set for use with the gas type as stated on the
packaging and repeated on the label affixed to the cooker.
. If necessary change the gas
To adapt the cooker fit suitable jets that provide the nominal flow rate and by
adjusting the air rings according to the information given on pages 26 to 28.
• For installation, the technician should:
. The cooker is Class 2 - Sub-class 1; furniture adjacent to the unit must not
be higher than the top of the cooker.
. The cooker has five adjustable feet for perfect levelling on the floor.
. Do not remove the cooker spacers at the back. Do not block the air outlet
between the back plate and the wall. These alterations can cause abnormal
heating of the cooker.
. Comply with the installation conditions stated on page 31 when fitting the
splash-back, optional accessory.
. Make the gas connection to the installation according to the gas supply,
page 29 to 30 , by connecting the gas supply pipe without forgetting to fit the
seal.
Caution – some countries require the use of a tapered fitting. You should
therefore replace the fitting mounted on the cooker with the tapered fitting.
. Connect the cooker electrically in compliance with the information given on
page 32/33.
. If the gas type has been changed, adjust the minimum flow of each gas
burner as described on page 30.
ANY MODIFICATION MADE TO THE GAS SETTING SHOULD BE NOTED ON
THE LABEL AFFIXED TO THE COOKER.
Installation
25 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rcp12pn

Table des Matières