Whirlpool SPOW 407 Mode D'emploi page 13

Clock function
You can adjust the real time by pressing TIMER
ON/CLOCK button. Press this button and hold for
over 3 seconds to activate the clock setting, clock
digit will flash, then using
get the correct time, press this button again, the
real time is set.
SLEEP mode
SLEEP mode can be set in COOLING,
HEATING or DRY operation mode.
This function gives you a more comfortable
environment with low noise level for sleep.
In SLEEP mode,
• The appliance will turn off automatically after
operating for 8 hours.
• Fan speed is automatically set at low speed.
• Set temperature will rise by max 1°C if the
appliance operates in cooling mode for 1 hour.
• Set temperature will decrease by 3°C at most if
the appliance operates in heating mode for 3
hours.
Note: In cooling mode, if room temperature is
26°C or above, set temperature will not change.
Heating is NOT available for cooling only air
conditioner.
Once sleep mode is set, "sleep" indicator on front
panel display will light up and "Running" indicator
will flash for 10 times, then the whole display will
light off.
JET mode
• JET mode is used to start or stop fast cooling or
Heating.
Fast cooling operates at high fan speed, and set
temperature automatically to 18°C.
Fast heating operates at auto fan speed,changing
set temperature automatically to 32 °C.
• In JET mode, you can set airflow direction or
timer. If you want to quit from JET mode, press
any - JET, MODE, FAN, ON/OFF or
TEMPERATURE SETTING button, the display
will return to the original mode.
Note:
• SLEEP and 6th Sense buttons are not available in
JET mode.
• The appliance will continue working in JET mode
if you don't quit from it by pressing any of the
buttons mentioned.
and buttons to
13