SPORT-ELEC multisportpro Mode D'emploi page 10

Masquer les pouces Voir aussi pour multisportpro:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
SAFETY PRECAUTIONS BY USING THE CREAM :
• In case of allergy, stop to apply the cream.
• Do not swallow.
• Do not leave with the range children.
• In case of contact with eyes rinse with water.
PRESENTATION OF THE BELT :
• Front side (photo III. A, page 4) :
1 - Central fasteners 2 - Wire storage 3 - Connection terminals 4 - Scratch strip
• Electrodes side (photo III. B, page 4) :
4 built-in electrodes
STEP 1 : CONNECTING AND FITTING THE BELT.
• Check your MULTISPORTPRO unit is STOPPED
• Take the (CEV8) connector (photo I. B, page 3) and connect it :
- To the belt connectors per groups of colour (photo III. C page 4).
- Then to the unit ( photo III. D, page 4).
• Apply a thick layer of electro conductive massage cream onto the electrodes built into the belt (domed part) (photo III E page 4)
• Place the belt or 2 half-belts onto the zone(s) to be stimulated, and adjust them using "scratch" strips to ensure the built-in elec-
trodes are properly in contact with the skin
Photos IV page 4 : A - stomach, B - back, C - arms, D - thighs, E - calf, F - back.
• Move the belt slightly on left or right (with device powered off ) to feel the contractions on the abdominal area.
If an electrode hurts or if you feel any tingling, stop the device, and check the electrode is properly smeared with cream.
TIP :
• Fitting the full belt :
To well-positioned the full belt at best, cross the 2 strips to flip the 2 ends on the outer scratch part (photos V. A page 4).
• Fitting the half-belt on the arm :
Adjust at the belt mid-size, according to the outline of your arm before positioning it, then start over if necessary to ensure
proper adjustment (photos V. B page 4).
STEP 2 : STARTING THE BELT FUNCTION
Once your unit is connected, install yourself comfortably and start your unit using the procedure "Starting the unit" detailed
previously in paragraph II.
STEP 3 : STOPPING THE BELT FUNCTION
Once the program is completed, disconnect the unit from the (CEV8) connector, and the latter from the belt.
Remove the excess cream on the built-in electrodes using a wipe dampened with water, then dry them.
18
IV. RECOMMENDATIONS OF USE
The unit is recommended for physiotherapists for functional re-education.
• You can restart a program's cycle on another muscle zone or change the program while remaining on the same muscle zone,
without exceeding however 40 min use per muscle zone and per day.
• For optimum use, refer to the diagrams shown in this leaflet.
• Clean the unit and its cables with a cloth dampened with a disinfecting solution (Mercryl type) diluted in water at 1/10
• The adhesive electrodes can be rehydrated before and after use with a disinfecting agent (e.g. Hexamedine).
• The adhesive electrodes must be repositioned on their support, and stored in a fresh storage between +5°C and +10°C.
• The adhesive electrodes have a lifetime of about 40 uses, you can order them directly from the online shop www.sport-elec.com,
or from your reseller.
PRECAUTIONS OF USE :
Do not use the unit on your face
f
f
Do not leave within reach of children
f
f
Ask for advice from your physician :
if you have electronic or metallic implants (pins, etc.)
f
f
in case of skin condition (wounds,...)
f
f
WARNINGS :
Keep away from children or people with mental disabilities.
f
f
The device contains small pieces that can be swallowed.
In order to prevent any risk of strangulation, please keep
f
f
the electrodes wires away from children.
If the device is not likely to be used for some time, the
f
f
batteries should be removed
Multisportpro is meant for personnal use. For reasons of
f
f
hygiene, the electrode should only be used on one person.
Do not use the device by driving or by working on a
f
f
machine.
Do not use this electro stimulation unit in a damp environ-
f
f
ment, a bathroom, a sauna, or close to electric machinery
connected to mains and earthed, or even piping earthed.
Use this device in a clean place (without dust nor dirt..).
f
f
The simultaneous connection of a patient to a high
f
f
frequency surgical unit may cause burns at the points of
contact of the stimulator's electrodes, and the stimulator
may be damaged.
Operation in close proximity of a short wave therapy unit
f
f
may cause instability in the stimulator's output power.
Do not, under any circumstances, attempt to open or
f
f
repair the Multisportpro yourself! Only have repairs carried
out by the customer service department.
CUSTOMER SUPPORT: +33 ( 0 ) 2 32 96 50 50
th
.
TROUBLE SHOOTING
If your device doesn't work properly, do not use it and
contact your retailer.
RECOMMENDATIONS :
Please apply regulations enforced in your country
when disposing your product at its end of life.
Therefore, please discard it in a location planned to
this effect, ensuring it is disposed in an environment-
friendly manner.
CONTRA-INDICATIONS :
Do not use SPORT-ELEC® :
on the heart area
f
f
If you carry a pacemaker
f
f
If you are pregnant
f
f
during first 6 weeks after baby birth
f
f
In case of neuromuscular diseases
f
f
In case of hemorrhagic diseases
f
f
On the face and skull
f
f
RECOMMENDATIONS FOR MAINTAINING AND
CLEANING THE BELT :
IMPORTANT : NEVER wash in machine and under running
water. The dryer and ironing facilities are forbidden.
Do not dry-clean
f
f
Do not expose to bleach
f
f
Clean the belt using a cloth dampened with a detergent,
f
f
then wipe with a dry cloth.
Clean the unit with a tissue dampened with a disinfecting
f
f
solution (Mercryl type) diluted with waterat 1/10th.
Clean the electrodes with a mix of water/hypoallergenic
f
f
detergent, then rinse thoroughly
19

Publicité

Table des Matières
loading

Table des Matières