Machine Operation; Dry Vacuuming; Machine Maintenance; Replacing Power Cord - Tennant V-CAN-12 Manuel D'utilisation

MACHINE OPERATION

DRY VACUUMING

1. Insert main filter into the tank (Fig. 1).
2. Mount the head on top of tank and lock it
with hooks (Fig. 2).
3. Push hose into hose inlet (Fig. 3).
4. Attach wand and desired tool to hose
ends (Fig. 4).
5. If your vacuum is equipped with paper
bag, slide paper bag over the deflector
(Fig. 6).
6. Plug power cord into a proper outlet and
turn cleaner on (Fig. 5).
1
3
5
ONLY V-CAN-16:
When the service indicator light turns on:
The vacuum bag is full → replace it
The main filter is clogged → clean the main
filter
The vacuum hose is clogged → unclog it
Stop using the vacuum cleaner if
the service indicator light turns on.
Overheating can take place, causing
permanent damages to the motor.

MACHINE MAINTENANCE

To keep machine in good working condition,
simply perform the following maintenance
procedures.
WARNING: Unplug cord from outlet
when not in use and before servicing
machine.
All repairs must be performed by a
qualified service person.
- Wipe machine housing with a cloth and
mild detergent.
- Inspect vacuum hose regularly for holes,
loose cuffs or clogged debris.
- Inspect power cord for damage. Coil cord
2
neatly after each use.
- Check bag for fullness, and replace it, if it's
necessary.
- Wash main filter by hand with a mild
detergent as needed. Let it dry thoroughly
before replacing. This will restore your main
filter so you can maintain good suction
4
performance.
- Replace the exhaust filter every 6 months
to ensure optimum filtering
6

REPLACING POWER CORD

1. Lift the flap
2. Remove the old power cord by pulling the
plug, not the cord.
3. Insert new power cord and close the flap
TENNANT V-CAN-12 / V-CAN-16
1
2
EN
3
7