Mounting The Machine On Your Back; Machine Operation - Tennant 3090 Opérateur Manuel Et Liste Des Piéces

OPERATION

MOUNTING THE MACHINE ON YOUR BACK

1. Fully loosen the shoulder straps and waistbelt then
mount the machine on your back. Do not tighten
shoulder straps at this time.
2. Position the harness on your back so that the
weight of the machine rests comfortably on your
hips. Then fasten and tighten the waistbelt.
NOTE: If necessary, readjust the shoulder harness
height adjustment straps as shown in order for
machine to rest on hips (Figure 12).
FIG. 12
3. After waistbelt is adjusted, attach the chest strap.
Then pull the shoulder adjustment straps
downward until shoulder harness is properly fitted
(Figure 13).
NOTE: To prevent shoulder fatigue, make sure that
the weight is resting on your hips.
FIG. 13

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Plug the power cord into a grounded electrical wall
outlet (Figure 14).
14
Home Home
Find... Go To.. Find... Go To..
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
Grounded
3 Hole Outlet
Ground Pin
FIG. 14
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
2. Press the main power switch to the ON position.
Select the desired speed by pressing the
HIGH/LOW switch (Figure 15).
FIG. 15
NOTE: Use the low speed setting as a whisper mode
when cleaning in areas that may have noise
restrictions.
3. With the appropriate accessory tool attached,
begin cleaning the area by working away from the
wall outlet. To prevent back fatigue, keep back
straight while cleaning (Figure 16).
FIG. 16
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
Tennant 3090 (05- -02)