Troubleshooting; Technical Specifications - Tennant V-CAN-12 Manuel D'utilisation

TROUBLESHOOTING

Problem
Machine does not run
Machine has little or no
suction
Only V-CAN-16
Machine has little suction Speed regulator is set at low speed Turn the knob of speed regulator
Only V-CAN-16
Service indicator light is
on and machine has little
or no suction

TECHNICAL SPECIFICATIONS

Voltage/Frequency
Max Motor Current
Motor Power
Max Airflow
Water lift
Tank Capacity
Standard microfiber bag capacity
Power cord length
Weight
Sound pressure level [dBA]
Protection
Cause
ON/OFF switch is off
Machine not plugged to wall outlet
Faulty on/off switch
Faulty power cord
Faulty vacuum motor
Hose is clogged
Holes in hose
Intake is clogged
Head is not securely latched
Worn gasket which is leaking air
Tank or bag is full
Vacuum bag is full
Main filter is clogged
Vacuum hose is clogged
V-CAN-12
120 V, 60 Hz
7 A
840 - 900 W max
157 m /h; 92 cfm
3
2.270 mmH
12 L; 3,2 Gal
11 L; 2,9 Gal
12 m; 3,3 ft
5,8 kg; 12,8 lb
63,0
IPX0
Solution
Turn switch to on
Plug power cord to wall outlet
Contact service center
Contact service center
Contact service center
Clear hose
Replace hose
Remove
obstruction
Close both latches down securely
Inspect all gaskets, replace if
necessary
Empty tank or bag.
at a higher speed
Replace vacuum bag
Clean the main filter
Unclog vacuum hose
V-CAN-16
120 V, 60 Hz
7 A
840 - 900 W max
157 m /h; 92 cfm
3
O; 89,37" 2.270 mmH
2
16 L; 4,2 Gal
11 L; 2,9 Gal
12 m; 3,3 ft
6.5 kg; 14,3 lb
52,0 ÷ 63,0
IPX0
TENNANT V-CAN-12 / V-CAN-16
EN
hose and clear
O; 89,37"
2
9