SKYLOTEC Jackpod Davit Instructions D'utilisation page 26

Mounting bases must be set up or installed and used on an anchorage meeting the strength requirements
as specified in Section 3.1. Bases other than the Skylotec Jackpod Davit Portable
Base shown in Figure 6 must be set up or installed following the Manufacturer's setup or installation
instructions provided with each base.
4.2 Jackpod Davit Portable Base
If you are using a Jackpod Base Portable with the Jackpod Arm, assemble the base as shown in Figure 6.
INSTALL LEGS
ADJUST LEGS
Figure 6, Assembling & Adjusting Jackpod Base Portable
1905 mm (75 ")
1371,6 mm (54 ")
Figure 7, Range of Opening Sizes for Jackpod Base Portable
By angling the base legs, position the base around the opening being entered so as to achieve the best
access to the opening for the entrant, and the best working position for the attendant.
Level the Base Assembly using the 4 Leveling Screws, adjusting the base such that the legs angle slightly
upwards as the go from back to front.
26