Lcd Monitor - Sony SU-WL500 Manuel D'installation

Masquer les pouces Voir aussi pour SU-WL500:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 104
1
Install the LCD Monitor onto the
Base Bracket.
 Referring to the Screw and Hook locations
diagram/table on page 28, determine the
holes of the Base Bracket for latching the
upper hooks of the Mounting Hook.
 Hold the LCD Monitor securely with both
hands, and gently align it on the wall.
WARNING
• Be sure that two or more persons (three or more
persons for 85 inches and above LCD Monitor set)
hold the LCD Monitor when carrying it.
• When carrying the LCD Monitor, hold it in
landscape orientation, and take care not to drop it
when installing. Do not apply excessive force to the
LCD Monitor; otherwise, it may be deformed.
Mounting Hook
18
(GB)
2
Confirming the
completion of the
installation
Follow the instructions in the SU-WL500 instruction
manual to confirm.
When removing the

LCD Monitor

Base Bracket
Follow the instructions in the SU-WL500 instruction
manual to remove.
Firmly secure the LCD Monitor
and the Base Bracket using the
screws supplied with SU-WL500
(+BVST4 × 12).
Note
• When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
WARNING
Be sure to tighten the securing screw firmly.
If you fail to do so, the LCD Monitor may fall
when it is pushed upward and cause injury.
Screw
(+BVST4 × 12)

Publicité

Table des Matières
loading

Table des Matières