Sony SU-WL500 Manuel D'installation page 7

4
Connect the AC power cord
(mains lead) and the connecting
cable(s) supplied with the LCD
Monitor to the LCD Monitor.
Connect the AC power cord (mains lead) and the
connecting cable(s) to the connectors on the
rear of the LCD Monitor. For details on
connecting the AC power cord (mains lead) and
the connecting cable(s), refer to the instruction
manual of the LCD Monitor.
Note
• You cannot connect the cables to the LCD Monitor
after installing it on the Base Bracket.
• Subcontract the cable routing in the wall to a
licensed contractor.
5
Detaching the Table-Top Stand
from the LCD Monitor.
 Remove one side of the Table-Top Stand at a
time. Firmly hold the Table-Top Stand
securely with both hands while the other
people lift up the LCD Monitor.
 Repeat the previous step and remove the
other side of the Table-Top Stand.
Note
• Three or more people are required to detach the
Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the LCD
Monitor as it may cause the LCD Monitor to fall
resulting in personal injury or physical damage to
the LCD Monitor.
• Take care when handling the Table-Top Stand to
prevent damage to the LCD Monitor.
• Be careful when lifting the LCD Monitor as the
Table-Top Stand is detached, the Table-Top Stand
may topple over and cause personal injury.
• Take care when removing the Table-Top Stand from
the LCD Monitor to prevent it from falling over and
damaging the surface that the LCD Monitor is
sitting on.
Step 5:
Installing the LCD
Monitor on the wall
WARNING
Be sure to complete the installation before
connecting the AC power cord (mains lead) to the
wall outlet. If you allow the AC power cord (mains
lead) to be pinched under or between pieces of
equipment, this may result in a short circuit or an
electric shock.
Be careful not to stumble over the AC power cord
(mains lead) or the LCD Monitor, as you may hurt
yourself.
7
(GB)