Lcd Display - Sony SU-WL500 Manuel D'installation

1
Install the LCD Display onto the
Base Bracket.
 Referring to the Screw and Hook locations
diagram/table on page 28, determine the
holes of the Base Bracket for latching the
upper hooks of the Mounting Hook.
 Hold the LCD Display securely with both
hands, and gently align it on the wall.
WARNING
• Be sure that two or more persons (three or more
persons for 85 inches and above LCD Display set)
hold the LCD Display when carrying it.
• When carrying the LCD Display, hold it in landscape
orientation, and take care not to drop it when
installing. Do not apply excessive force to the LCD
Display; otherwise, it may be deformed.
Mounting Hook
18
(US)
2
Confirming the
completion of the
installation
Follow the instructions in the SU-WL500 instruction
manual to confirm.
When removing the

LCD Display

Base Bracket
Follow the instructions in the SU-WL500 instruction
manual to remove.
Firmly secure the LCD Display
and the Base Bracket using the
screws supplied with SU-WL500
(+BVST4 × 12).
Note
• When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
WARNING
Be sure to tighten the securing screw firmly.
If you fail to do so, the LCD Display may fall
when it is pushed upward and cause injury.
Screw
(+BVST4 × 12)