Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Fence
Ⓑ
Table on base
Cutting method of crown molding without tilting the saw blade
Crown molding vise ass'y
(optional accessories)
6mm knob bolt
Crown molding stopper (L)
(Optional accessories)
6mm wing
bolt
Fig. 45-a
(2) The crown molding vise (B) (Optional accessory) can be mounted on the base. It can
unite with the slope of the crown molding and vice can be pressed down.
Then turn the upper knob, as necessary, to securely attach the crown molding in
position. To raise or lower the vise assembly, fi rst loosen the hex. socket set screw.
Crown molding vise ass'y
(Optional accessories)
Hex. socket
set screw
Crown molding
Fig. 45-b
34
Ⓐ
Fig. 43
Crown molding stopper (R)
(optional accessories)
6mm knob
bolt
Knob
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
Fence
Ⓐ
Table on base
Fig. 44
(1) Crown molding Stopper (L) and (R)
(optional accessories) allow easier cuts
of crown molding without tilting the saw
blade. Install them in the base both-
sides side to be shown in Fig. 45-a. After
inserting Tighten the 6mm knob bolts to
secure the crown molding Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include
Crown molding Stopper (L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
After
adjusting
upper knob, as necessary, to securely
attach
the
crown
(See Fig. 45-b)
Ⓑ
the
height,
turn
molding
in
position.
the
Publicité
Table des Matières
