Hitachi Koki C12RSH2 Instructions De Sécurité Et Mode D'emploi page 28

English
WARNING:
* For slide cutting, follow the procedures indicated above in Fig. 27.
* Always return the carriage to the full rear position after each
* Never put your hand on the side handle during the cutting operation
7. Bevel cutting procedures
Clamp
Lever
Indicator
(for right
bevel scale)
Bevel
scale
Fig. 28
WARNING:
28
Forward slide cutting (toward the operator) is very dangerous
because the saw blade could kick upward from the workpiece.
Therefore, always slide the handle away from the operator.
crosscut operation in order to reduce the risk of injury.
because the saw blade comes close to the side handle when the
motor head is lowered.
Holder (A)
Set pin (A)
Pull
When the workpiece is secured on the left or right side of the
blade, the short cut-off portion will come to rest on the right or
left side of the saw blade. Always turn the power off and let the
saw blade stop completely before raising the handle from the
workpiece.
If the handle is raised while the saw blade is still rotating, the
cut-off piece may become jammed against the saw blade causing
fragments to scatter about dangerously.
When stopping the bevel cutting operation halfway, start cutting
after pulling back the motor head to the initial position.
Starting from halfway, without pulling back, causes the lower
guard to be caught in the cutting groove of the workpiece and to
contact the saw blade.
(1) Loosen the clamp lever and bevel the saw blade to
the left or to the right.
When tilting the motor head to the right pull the set
pin (A) towards the rear.
The clamp lever adopts a latchet system. When
contacting the work bench and the main body,
pull the clamp lever in the direction of the arrow
mark as illustrated in Fig. 28, and change the
direction of the clamp lever.
(2) Adjust the bevel angle to the desired setting while
watching the bevel angle scale and indicator, then
secure the clamp lever.
(3) Follow the procedures indicated in paragraphs
4,5 and 6 above. For maximum dimensions for
bevel cutting, refer to "SPECIFICATIONS" table on
page 12.