Hitachi Koki C12RSH2 Instructions De Sécurité Et Mode D'emploi page 25

Masquer les pouces Voir aussi pour C12RSH2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.
Using the Vise Assembly (Standard accessory)
Screw holder
Hex. socket
set screw
Vise shaft
Fence
Fig. 23
WARNING:
CAUTION:
3.
Cutting Operation
Marking
Marking
(pre-marked)
(pre-marked)
(Front view)
(3) Once the saw blade contacts the workpiece, push the handle down gradually to cut into the
workpiece.
Knob
(1) The vise assembly can be mounted on the base.
(2) Turn the upper knob and securely fi x the workpiece
Vise plate
Workpiece
Always fi rmly clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
Always confi rm that the motor head (see Fig. 1) does not contact
the vise assembly when it is lowered for cutting. If there is any
danger that it may do so, loosen the Hex. socket set screw and
move the vise assembly to a position where it will not contact the
saw blade.
Adjusting line
Saw blade
Fig. 24
in position (Fig. 23).
(1) As shown in Fig. 24 the width
(2) Once the saw blade reaches
of the saw blade is the width
of the cut. Therefore, slide the
workpiece to the right (viewed
from the operator's position)
when length ⓑ is desired, or
to the left when length ⓐ is
desired.
If a laser marker is used, align
the laser line with the left side
of the saw blade, and then
align the ink line with the laser
line.
maximum speed, push the
handle down carefully until
the saw blade approaches the
workpiece.
English
25

Publicité

Table des Matières
loading

Table des Matières