Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
8.
Bevel angle fi ne adjustment
Handle
(1)
Grip the handle on the motor head and position it at the bevel angle you need.
(2) After adjusting to the desired angle, tighten the clamp lever and clamp the motor head.
CAUTION:
When cutting a workpiece of 2-15/16" (75 mm) height in the left
45° bevel cutting position or a workpiece of 1-15/16" (50 mm)
height in the right 45° bevel cutting position, adjust the lower
limit position of the motor head so that the gap between the lower
edge of the motor head and the workpiece will be 5/64" to 1/8" (2
to 3 mm) at the lower limit position (refer to "2. Checking the saw
blade lower limit position" on page 18).
Clamp lever
8 mm bolt (B)
Fig. 29
* If not tightened fi rmly enough the motor head might suddenly
move or slip, causing injuries. Be sure to tighten the motor head
section enough so it will not move.
* Always check that the clamp lever is secured and the motor
head is clamped. If you attempt angle cutting without clamping
the motor head, then the motor head might shift unexpectedly
causing injuries.
English
Clamp lever
Fig. 30
29
Publicité
Table des Matières
