Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 4-7/32" (107 mm) in height in right-
angle cutting or 2-3/4"(70 mm) in left bevel angle cutting or 1-3/4" (45 mm)
in right bevel angle cutting, adjust the lower limit position so that the base
of the motor head (see Fig. 9-a) will not come in contact with the workpiece.
To adjust the lower limit position of the saw blade, follow the procedure (1) shown in Fig. 9-a.
○
Lower the motor head, and turn the 8 mm depth adjustment bolt and make adjustments
so that there can be a clearance of 5/64" to 1/8" (2 mm to 3 mm) between the lower limit
position of the motor head and the top of the workpiece at the saw blade's lower limit
position where the head of the 8 mm depth adjustment bolt contacts the hinge.
4.
Confi rmation for use of sub fence (A)
WARNING:
Sub fence (A)
6 mm wing bolt
5.
Confi rmation for use of sub fence (B)
WARNING
Sub fence (B)
Fence (B)
6 mm wing bolt
When right angle cutting, loosen the 6 mm wing bolt, then slide
the sub fence (A) outward and remove it.
Failure to do so may result in the main body or saw blade coming
into contact with the sub fence (A) and causing injury.
Fence (A)
Fig. 10
: When left angle cutting, loosen the 6 mm wing bolt, then slide the
sub fence (B) outward.
Failure to do so may result in the main body or saw blade coming
into contact with the sub fence (B) and causing injury.
Fig. 11
This power tool is equipped with a sub fence
(A).
In the case of direct angle cutting and left bevel
angle cutting, use the sub fence (A). Then, you
can realize stable cutting of the material with a
wide back face.
When right angle cutting, loosen the 6 mm
wing bolt, then slide the sub fence (A) outward
and remove it, as shown in Fig. 10.
This power tool is equipped with a sub fence
(B). In the case of direct angle cutting and
right bevel angle cutting, use the sub fence
(B). Then, you can realize stable cutting of the
material with a wide back face. When left angle
cutting, loosen the 6 mm wing bolt, then slide
the sub fence (B) outward, as shown in Fig. 11.
English
19
Publicité
Table des Matières
