Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
(4)
After cutting the workpiece to the desired depth, turn the power tool OFF and let the saw
blade stop completely before raising the handle from the workpiece to return it to the full
retract position.
CAUTION:
WARNING:
4.
Cutting narrow workpieces (Press cutting)
Hinge
Holder (A)
Fig. 25
26
Increased pressure on the handle will not increase the cutting
speed.
On the contrary, too much pressure may result in overload of
the motor and/or decreased cutting effi ciency.
* Confi rm that the trigger switch is turned OFF and the power
plug has been removed from the receptacle whenever the tool
is not in use.
* Always turn the power off and let the saw blade stop completely
before raising the handle from the workpiece.
If the handle is raised while the saw blade is still rotating,
the cut-off piece may become jammed against the saw blade
causing fragments to scatter about dangerously.
* Every time one cutting or deep-cutting operation is fi nished,
turn the trigger switch off , and check that the saw blade has
stopped. Then raise the handle, and return it to the full retract
position.
* Be absolutely sure to remove the cut material from the top of
the turntable, and then proceed to the next step.
* Continued cutting operation can result in overload of the motor.
Touch the motor and if it's hot, stop your cutting operation once
and rest for 10 minutes or so, and then restart your cutting
operation.
* Do not operate the head section or lift up the main unit while
grasping the digital display (Fig. 1) as this could cause damage
to the digital display.
Handle
Press
down
Workpiece
Slide the hinge down to holder (A), then tighten
the slide securing knob (see Fig. 2) as indicated
in Fig. 25
Lower the handle to cut the workpiece.
Using the power tool this way will permit cutting
of workpieces of up to 4-3/16" (107 mm) square.
Publicité
Table des Matières
