Güde MBS 115 Traduction Du Mode D'emploi D'origine page 24

Device-specific safety instructions
Use the right saw band at all times.
The device must be switched off before inserting material to be
cut in the vice or before removing material to be cut from the vice.
Keep your hands and fingers in a safe distance from the running
saw band at all times.
The saw band must not be braked by hand.
Safety equipment and guards, etc. must not be removed.
Never remove the cuts by hand. Use a brush at all times.
Never leave the device when in operation.
Assembly
Pull out the ratchet (pic. 1)for uncovering.
Length stop:
Screw the guide rail to the thread and fixate the length stop by
the screw (pic.12)
Before putting the device into operation
The working surface and area must be sufficiently lit at all times.
Put the device on a flat, horizontal surface and check the device
if stable. Do not place the device on wall.
There must be no person in the dangerous area.
The minimum safety distance of 10m must be respected.
Noise of the metal-cutting band saw is app. 90 dB. Ear
protectors to be used at all times!
Saw band
Unplug the device before any adjustment and servicing!
Saw band stretching:
Stretch the saw band using the stretching bolt (pic. 15).
The saw band is stretched correctly when it can be pressed by 2-
3 mm.
Guide adjustment:
The saw band guide must be adjusted as, otherwise, it could get
flipped over, which would result in an unclean cut.
Loosen the bolt (pic. 15/1) and adjust the guide depending on
the width of the material to be processed.
Changing the saw band:
Loosen the saw band.
Loosen the bolt and remove the cover. Now fit in a new saw
band on the rollers and place it between the guide bearing and
the band guide. Then, stretch the saw band again and close the
covers safely and firmly.
Operating the device
Angle adjustment:
Adjust the angle to the material to be processed at all times.
To shift the entire work block, loosen the bolt (pic. 13/1).
Using both stops, precise adjustment of 0° +45 is possible
(pic. 13/2a).
Cutting speed:
The cutting speed always depends on the material being cut.
Speed can be changed by turning the knob (pic. 16).
Marking
Product safety:
Product corresponds to
applicable EU standards
Prohibitions:
Protect against rain, wet and
weather conditions!
Warning:
Warning/Caution
Keep safe distance!
Commands:
Please read carefully the
Operating Instructions.
Wear ear protectors and
protective glasses!
Environment protection:
Dispose waste professionally so
as not harm the environment.
Any defective and/or disposed
electric or electronic devices
must be delivered to respective
collection centres.
Package:
Protect against moisture!
Caution – Fragile!
This side up!
Technical specifications:
Voltage ~ Frequency
No pulling the cable/carrying by
cable!
Warning against dangerous
voltage
Wear protective gloves!
Packing cardboard material may
be delivered to collecting centres
for recycling.
Interseroh-Recycling system
with serial number
Engine power